Yealink VC110 - Page 65

Configuring Network
55
5. Press the Save soft key to accept the change.
The display device prompts ―Reboot now?‖.
6. Select OK to reboot the endpoint immediately.
If DHCP is disabled or the endpoint cannot obtain network settings from the DHCP
server, you need to configure them manually.
The following parameters should be configured for endpoints to establish network
connectivity:
 IP Address: Configure the endpoint to use the assigned IP address.
 Subnet Mask: Enter the subnet mask address when the endpoint does not
automatically obtain the subnet mask.
 Gateway: A gateway is a network point that works as an entrance to another
network.
 Primary DNS /Secondary DNS: Domain Name System (DNS) servers translates
domain names (for example: www.example.com), which can be easily memorized
by humans, to the numerical IP addresses (192.168.1.15) needed for the purpose of
computer services and devices worldwide.
Network parameters need to be configured manually on the endpoint are described
below.
Parameter
Description
Configuration Method
Static IP
Enables or disables the endpoint
to use manually configured
network settings.
Default: Disabled
Note: If you change this
parameter, the endpoint will
reboot to make the change take
effect.
Web User Interface
IP Address
Configures the IP address
assigned to the endpoint.
Default: Blank
Note: If you change this
parameter, the endpoint will
reboot to make the change take
effect.
Remote Control
Web User Interface
Subnet Mask
Configures the subnet mask
assigned to the endpoint.
Remote Control
Web User Interface