Administrator‘s Guide for Yealink VC110 Video Conferencing Endpoint
58
10 Mbps Half Duplex
100 Mbps Half Duplex
10 Mbps Full Duplex
100 Mbps Full Duplex
Auto is configured on the endpoint by default.
Auto
Auto means that the switch will negotiate the network speed and duplex mode for the
endpoints to transmit voice or data over Ethernet. This process entails devices first
sharing transmission capabilities and then selecting the highest performance
transmission mode supported by both endpoints.
Half-duplex
Half-duplex transmission refers to transmitting voice or data in both directions, but in
one direction at a time; this means one endpoint can send data on the line, but not
receive data simultaneously.
Full-duplex
Full-duplex transmission refers to transmitting voice or data in both directions at the
same time; this means one endpoint can send data on the line while also receiving
data.
Parameter of network speed feature on the endpoint is described below:
Specifies the network speed and
duplex mode for the endpoint to
use.
Default: Auto
Note: If Auto is selected, the
network speed and duplex mode
will be negotiated by the switch
automatically.
The network speed and duplex
mode you select must be
supported by the switch.
If you change this parameter, the
endpoint will reboot to make the
change take effect.
To Next Page
Loading...
