Configuring Network
57
3. Enter the IP address, subnet mask, default gateway, primary DNS and secondary
DNS in the corresponding fields.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5. Click Confirm to reboot the endpoint immediately.
To configure network settings manually via the remote control:
1. Select Menu->Advanced (default password: 0000) ->LAN Configuration.
2. Uncheck the DHCP checkbox.
3. Enter the desired values in the IP Address, Subnet Mask, Gateway, DNS Primary
Server and DNS Secondary Server fields respectively.
4. Press the Save soft key to accept the change.
The display device prompts ―Reboot now?‖.
5. Select OK to reboot the endpoint immediately.
You can configure the network speed and duplex mode the endpoint uses. The network
speed and duplex mode you select for the endpoint must be supported by the switch.
The network speeds and duplex modes supported by the endpoint are:
Auto
To Next Page
Loading...
