Configuring Network
63
3. Enter the desired time interval in the Packet Interval (1-3600s) field.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
5. Click Confirm to reboot the endpoint immediately.
To configure LLDP via the remote control:
1. Select Menu->Advanced (default password: 0000) ->Advanced Network.
2. In the LLDP block, check the Active checkbox.
3. Enter the desired value in the Packet Interval (1-3600s) field.
4. Press the Save soft key to accept the change.
The display device prompts ―Reboot now?‖.
5. Select OK to reboot the endpoint immediately.
VLAN is disabled on endpoints by default. You can configure VLAN manually. Before
configuring VLAN on the endpoints, you need to obtain the VLAN ID from your network
administrator.
Parameters of manual VLAN on the endpoint are described below.
Enables or disables VLAN for the
Internet (WAN) port.
Default: Disabled
Note: If you change this
parameter, the endpoint will
reboot to make the change take
effect.
Remote Control
Web User Interface
To Next Page
Loading...
