Yealink VC110 - Page 72

Administrator‘s Guide for Yealink VC110 Video Conferencing Endpoint
62
TLV Type
TLV Name
Description
Number
Inventory –
Manufacturer Name
Manufacturer name of the endpoint.
The default value is ―IP_Phone‖.
Inventory – Model
Name
Model name of the endpoint.
The default value is ―VC110‖.
Asset ID
Assertion identifier of the endpoint.
Parameters of LLDP feature on the endpoint are described below.
Parameter
Description
Configuration Method
LLDP->Active
Enables or disables LLDP feature
on the endpoint.
Default: Enabled
Note: If you change this
parameter, the endpoint will
reboot to make the change take
effect.
Remote Control
Web User Interface
Packet
Interval(1-3600s)
Configures the interval (in
seconds) for the endpoint to send
LLDP requests.
Default: 60
Note: If you change this
parameter, the endpoint will
reboot to make the change take
effect.
Remote Control
Web User Interface
To configure LLDP via the web user interface:
1. Click on Network->Advanced.
2. In the LLDP block, select the desired value from the pull-down list of Active.