Yealink VC110 - Bandwidth Settings

Administrator‘s Guide for Yealink VC110 Video Conferencing Endpoint
68
Parameter
Description
Configuration Method
EAP-TTLS/EAP-MSCHAPV2.
Note: If you change this
parameter, the endpoint will
reboot to make the change take
effect.
Device
Certificates
Configures the access URL of the
device certificate when the
802.1x authentication mode is
configured as EAP-TLS.
Note: If you change this
parameter, the endpoint will
reboot to make the change take
effect.
Web User Interface
To configure 802.1X via the web user interface:
1. Click on Network->Advanced.
2. In the 802.1x block, select the desired protocol from the pull-down list of Mode
802.1x.
a) If you select EAP-MD5:
1) Enter the user name for authentication in the Identity field.
2) Enter the password for authentication in the MD5 Password field.
b) If you select EAP-TLS:
1) Enter the user name for authentication in the Identity field.
2) Leave the MD5 Password field blank.