Yealink VC110 - Page 93

Configuring Network
83
Parameter
Description
Configuration Method
 StaticNat
Default: Disabled
Note: STUN works only if this
parameter is set to STUN.
To configure STUN server via web user interface:
1. Click on Network->NAT/Firewall.
2. In the Stun Config block, select the desired value from the pull-down list of Active.
3. Enter the IP address or the domain name of the STUN server in the STUN Server
field.
4. Enter the port of the STUN server in the Port field.
5. Click Confirm to accept the change.