MyPBX Standard V6/V7 Administrator's Guide
www.yeastar.com Page 107
.Maximum concurrent calls
Maximum concurrent calls limits. The default value 0 means no limit
·Music on hold
Used to set hold music for the system.
·Tone Region
Please select your country or nearest neighboring country to enable the default
dial tone, busy tone, and ring tone for your region.
Note: please reboot the system to take effect.
·HTTP bind port/Web Access Port
Port to use for HTTP sessions; Default: 80
Note: please reboot the system to take effect.
·Dsp Fax
Enable Dsp to optimize Fax reception.
·FXO Mode
FXO port‘s operation mode.
·Virtual Ring Back Tone
It‘s only for GSM/UMTS trunk. Once enabled, when the caller call out with
GSM/UMTS trunks, the caller will only hear the virtual ring back tone generated
by the system before callee answers the call.
·Distinctive Caller ID
When incoming calls are routed from ring group/queue/IVR, the caller ID
displays with the name of ring group/queue/IVR, for example 5503302
(ringgroup_default).
Note: To display IVR's name, please press the key instead of the extension
number directly.
·Attended Transfer Caller ID
When transferring an incoming call using the attended transfer feature code or
the transfer key of IP phone, the Caller ID of transferee or transferer displayed
on the screen of the callee. The default display is the Caller ID of the initiator.
For example, if extension 500 makes a call to extension 501. After 501 picks up
the call, 501 makes an attended transfer to extension 502. If
selecting ―Transferer‖, 502 will display the Caller ID as 500; if
selecting ―Transferee‖, 502 will display the Caller ID as 501.
·Follow Me Prompt
To Next Page
Loading...
Need help?
General
