MyPBX Standard V6/V7 Administrator's Guide
www.yeastar.com Page 144
APPENDIX A FAQ
Q1. How to Register SIP devices?
A1:
1) Register SIP softphone
Download the x-lite softphone from CounterPath website
www.counterpath.com
After installing the x-lite, right click the panel and select the SIP Account setting
and then configure it.
Display Name: 500
User Name: 500
Password: 500
Authorization Name: 500
Domain: 192.168.5.150
2) Register IP Phone (for example, Yealink‘s T28 IP Phone)
a) Connect the T28‘s Internet port to the switch. And it can get the IP from your
route.
b) Press the ―OK‖ key on T28 to get the IP of T28.
c) Put the IP on web browser then you can enter the T28 configure page through
this IP.
d) Put the SIP extensions info on the T28 IP phones.
Display Name: 501
User Name: 501
Register Name: 501
Password: 501
SIP Server: 192.168.5.150
Use the same method register another T28 to other extension.
Q2. How do I reset MyPBX back to the factory default settings?
A2: To perform a reset, please follow steps below:
Step 1: Press down the ―Reset‖ button on the back of the unit for 5 seconds and
watch the LEDs on the front of the MyPBX. When the status LED turns red, let go
of the reset button.
Step2: When the RUN status LED starts blinking, MyPBX will be set back to
factory defaults.
Step 3: To access the configuration page, navigate to 192.168.5.150 using a
web browser. Make sure that you are on the 192.168.5.0 subnet before doing
this.
Step 4: Login to the device with the username ―admin‖ and the
password ―password‖, and reconfigure the device.
To Next Page
Loading...
Need help?
General
