Yeastar Technology MyPBX Standard V6 User Manual

MyPBX Standard V6/V7 Administrator's Guide
www.yeastar.com Page 18
5.1.2 WAN Settings
Figure 5-2 WAN Settings
It supports three connection types: DHCP (obtain an IP automatically), PPPoE,
Static IP Address.
Notes:
1. WAN port is disabled by default.
2. WAN port cannot be used as a router to route the Internet packages from
WAN port to LAN port.
·DHCP
If your ISP says that you are connecting through DHCP or a dynamic IP address,
perform these steps:
Step1: Select DHCP as the WAN Connection Type.
Step2: Click Save button to save the settings.
Step3: Reboot the device.
Step4: Check the WAN Status (Status  Network status).
·Static IP Address
If your ISP says that you are connecting through a static or fixed IP address,
perform these steps:
Step1: Select Static IP Address as the WAN Connection Type.
Step2: Enter the IP Address.
Step3: Enter the Subnet Mask.
Step4: Enter the Gateway Address.
Step5: Enter the Primary DNS and Secondary DNS.
Step6: Click the Save button to save the settings.
Step7: Reboot the device.
Step8: Check the WAN Status (Status  Network status).

Yeastar Technology MyPBX Standard V6 Specifications

General

Brand	Yeastar Technology
Model	MyPBX Standard V6
Category	Switch
Language	English