MyPBX Standard V6/V7 Administrator's Guide
www.yeastar.com Page 118
domain name.
·TLS Client Method
When using MyPBX as TLS client, specify the protocol for outbound TLS
connections. You can select it as tlsv1, sslv2 or sslv3.
·RTP Port Start
Beginning of RTP port range.
·RTP Port End
End of RTP port range.
·DTMF Mode
Set default mode for sending DTMF. Default setting: rfc2833.
·Max Registration/Subscription Time
Maximum duration (in seconds) of a SIP registration. The default is 3600
seconds.
·Min Registration/Subscription Time
Minimum duration (in seconds) of a SIP registration. The default is 60 seconds.
·Default Incoming/Outgoing Registration Time
Default Incoming/Outgoing Registration Time: Default duration (in seconds) of
incoming/outgoing registration.
·Register Attempts
The number of SIP REGISTER messages to send to a SIP Registrar before giving
up. Default is 0 (no limit).
·Register Timeout
Number of seconds to wait for a response from a SIP Registrar before
considering the register has timed out. The default is 20 seconds.
·Calling Channel Codec Priority
Once enabled, when dialing out via SIP/SPS trunks, the codec of calling channel
will be selected in preference. If not, MyPBX will follow the priority in your
SIP/SPS trunks.
·Video Support
Support for SIP video or no. The default is yes.
·Max Bit Rate
Configure the max bit rate for video stream. The default: 384kb/s
To Next Page
Loading...
Need help?
General
