Yeastar Technology MyPBX Standard V6 User Manual

MyPBX Standard V6/V7 Administrator's Guide
www.yeastar.com Page 123
Where to get the caller ID in SIP packet.
·To Field
Where to get the DID in SIP packet.
·180 Ringing
It is set when the telecom provider needs. Usually it is not needed.
·Remote Party ID
Whether to send Remote-Party-ID on SIP header or not. Default: no.
·Allow Guest
Whether to allow anonymous registration extension or not. Default: no.
This option is used to avoid some anonymous calls by hackers. For more details
about the system security configuration, please refer to APPENDIX B MyPBX
Security Configuration Guide.
·Pedantic
Enable pedantic parameter. Default: no.
·Alwaysauthreject
If enabled, when MyPBX rejects ―Register‖ or ―Invite‖ packets, MyPBX always
respond the packets using ―SIP404 NOT FOUND‖.
·OPTIONS Response 200
If set to yes, the response to an OPTIONS is always 200 OK.
·Session -timers
Enable session-timer mode, default: yes.
·Session-expires
The max refresh interval.
·Session-minSE
The min refresh interval, which mustn't be less than 90s.
·Session-refresher
Choose session-refresher, the default is Uas.

Yeastar Technology MyPBX Standard V6 Specifications

General

Brand	Yeastar Technology
Model	MyPBX Standard V6
Category	Switch
Language	English