MyPBX Standard V6/V7 Administrator's Guide
www.yeastar.com Page 52
·Caller ID
The Caller ID will be used when this user calls another internal extension.
·Register Name
It is for extension registration validation. Users will not be able register the
extension if the authorization name is incorrect even though the username and
password are correct.
2) Voicemail
·Enable Voicemail
Check this box if the user should have a voicemail account.
·Voicemail Access PIN
The voicemail password for this extension, e.g. ―1234‖.
3) Mail Setting
This option defines whether or not voicemails or faxes are sent to an Email
Address as an attachment.
·Enable Send Voicemail
Once enabled, the voicemail will be sent to email as an attachment.
·Email Address
Email address used to receive the voicemail or Fax.
Note: Please ensure that the section ―SMTP Settings For Voicemail‖ (in the
―Voicemail Settings‖) has been properly configured before using this feature.
4) Group
·Pickup Group
If this extension belongs to a pickup group, any calls that ring this extension can
be picked up by other extensions in the same pickup group by dialing the Call
Pickup feature code (the default is *4).
Note: *4 is the default setting, it can be changed under Feature Codes ->
General -> Call Pickup.
5) Call Duration Settings
Set up the max cull duration for every call of this extension, but it‘s only valid for
outbound calls. Enter ―0‖ or leave this blank empty, the value would be equal to
the max call duration configured in the Option Settings page.
Note: This setting will not be valid for internal calls.
To Next Page
Loading...
Need help?
General
