7-30
IM AQ1210-01EN
Executing the Zero Set
3.
Tap ZERO SET.
Remove the optical fiber cables from the instrument and close the OPM port covers, or make sure that the
power meter is not receiving any light, and then start the optical power meter zero set procedure.
Measuring the Optical Power
4.
Set the wavelength.
5.
Connect an optical fiber cable to the OTDR port (PORT1). The measured value is displayed on
the power meter screen. For the position of the OTDR port (PORT1), see “Component Names
and Functions” in the Getting Started Guide, IM AQ1210-02EN.
Soft Key Menu (power checker)
6.
Tap the soft key menu display button. A power checker soft key menu appears.
7.5 Using the Power Checker (/PC option)
To Next Page
Loading...
