YOKOGAWA AQ1215A - Page 173

8-2
IM AQ1210-01EN
OTDR Smart Mapper Screen
Set the wavelength.
See section 2.1.
Set the pulse width.
See section 2.1.
Save data directly.
See section 4.4.
Set the attenuation.
See sec. 2.1.
Set the distance range. See section 2.1.
Set the IOR. See section 2.2.
Set the averaging conditions.
See section 2.1.
Performing Setup
3.
Press SETUP to display the OTDR Smart Mapper setup screen.
Measurement (Measure) Conditions
4.
Tap the MEASURE tab to display the following screen.
Set the wavelength (1310nm, 1550nm, 1625nm/1650nm).
Set the distance range.
(AUTO, 200m, 500m, 1km, 2km, 5km, 10km, 20km, 30km,
40km, 50km, 100km, 200km, 256km, 300km, 400km, 512km)
Set the fiber-in-use alarm (OFF, ON).
Set auto save.
MEASURE tab
Initializes the
measurement
settings
Set the connection
check (OFF, ON).
Note
For details on the setup screen that appears when you select a setting and the descriptions of the settings,
see section 2.1.
8.1 Displaying a Map of the Line Configuration and Events (OTDR Smart Mapper)