5-4 <5. Functions of CQ1 Software>
IM 80J01A01-01E
(3) Load Measurement Protocol
Load measurement condition fle designated by file read-in dialog.
In CQ mode, conditions such as objective lens, sample vessel, Z
stack, Fields to be imaged and analysis conditions are applied.
Fields to be imaged aren’t applied if stage attachment and sample
holder isn’t matched.
In HDD mode, only analysis conditions are applied.
(4) Save Contrast and Region View Setting
This function is valid only in HDD mode. Save “Contrast
Enhancement” and “Region” setting of Tool function (Refer to
5.6.9 Tool Function). In case of not analyzed data, only “Contrast
Enhancement” setting is saved.
(5) Exit
Exit from CQ1 Software.
To Next Page
Loading...
Need help?
General
