<5. Functions of CQ1 Software> 5-45
IM 80J01A01-01E
(7) Edit Object Detect Setting
Edit object detect settings. Up to 10 objects can be added.
Object list to detect
Show the list of object detect setting
Show if the detected object is being linked or not.
Edit name of the object to detect
Select object detect channel.
Only the confocal channel is selectable.
However, Phase Contrast channel is selected if no confocal
channel is installed.
Add
Add an Object Detect Setting to the end of the list.
Copy
Copy selected Object Detect Setting and add to the end of the list.
However, Link cannot be copied.
Remove
Remove selected Object Detect Setting.
Raise up analysis order of selected Object Detect Setting by one
step.
Step down analysis order of the selected Object Detect Setting by
one step.
OK
Close window after confirming the object Detect Setting. If a
warning sign appears, reconfirm the Protocol at “Analysis” window.
To Next Page
Loading...
