YOKOGAWA GX20

1-1
IM 04L51B01-01EN
Configuring the GX/GP and Viewing the Settings
1
2
3
4
5
App
Index
SetupGuide(Readthisfirst)
GX/GP Setup Procedure
To use the GX/GP, follow the procedure below to configure it.
To assign channel displays (display group settings)
automatically, initialize.
To assign them manually, do it in “Configure settings.”
Set the measurement mode according to the
measurement conditions.
Connected expandable I/O, GM sub unit, and installed
modules are identified, and the system is reconfigured.
If you change the system configuration, you need to
reconfigure.
1
2
3
4
Set the measurement mode.
Make the main unit recognize the modules.
(Reconfigure the GX/GP.)
Channel displays are assigned automatically along
with initialization.
Assign channel displays.
Assign manually
Initialize
Assign automatically
Configure the GX/GP settings.
See the various settings from section 1.1.
Operation: 1.29.1, “Initializing the Settings and the
Internal Memory”
Configuration flowchart
Set the date and time.
1
5
Configure settings.
1 If you need to set the time zone or Daylight Saving
Time (DST) or both, do so before setting the date
and time.
Operation: 1.29.4, “Reconfiguring the GX/GP”
Operation: 1.29.3, “Setting the Measurement Mode”
Chapter 1 ConfiguringtheGX/GPandViewingtheSettings