5-14
IM 04L51B01-01EN
5
Select the module you want to calibrate, and tap Next.
An I/O selection screen appears.
Go to channel selection
Returns the calibration values to their factory defaults
Returns to the module selection screen
Exits from calibration mode
6
Select Input calibration, and tap Next.
The channel selection screen appears.
7
Select the channel you want to calibrate, and tap Next.
Writes (saves) calibration values
Returns to the module selection screen
Exits from calibration mode
Calibrates the selected range
5.1 Maintenance
To Next Page
Loading...
Need help?
General
