Getting Started
32
10.Replace the access door.
Figure 25 Replace Access Door
11.Press the access door down and ensure that it is properly seated.
12.Insert the battery, bottom first, into the battery compartment in the back of the device.
13.Press the battery down until the battery release latch snaps into place.
14.Replace the hand strap, if required.
15.Press and hold the Power button to turn on the device.
Replacing the microSD Card
To replace the microSD card:
1. Press the Power button until the menu appears.
2. Touch Power off.
3. Touch OK.
4. If hand strap is attached, slide the hand strap clip up toward the top of the device and then lift.
Figure 26 Remove Hand Strap Clip
5. Press the two battery latches in.
6. Lift the battery from the device.
To Next Page
Loading...