Zebra ZD410 - Issue: Non-continuous labels act as Continuous labels.; Issue: Printer Locks-Up

Troubleshooting
134
Issue: Non-continuous labels act as Continuous labels.
A non-continuous label format with matching media loaded in the printer, was sent to the printer but prints
like it is continuous media.
Possible Cause - 1
The printer was not calibrated for the media being used.
Possible Cause - 2
The printer is configured for continuous media.
Resolution
Set the printer for the correct media type (gap/notch, continuous, or mark) and calibrate the printer using
Run a SmartCal Media Calibration, if necessary use Manual Media Calibration for hard to calibrate media
types.
Issue: Printer Locks-Up
All indicator lights are on and the printer locks up or the printer locks up while restarting.
Possible Cause - 1
The printer memory has been corrupted by an unknown event.
Resolution - 1
1 — Reset the printer to factory defaults. See use the Zebra Setup Utility and Open Printer Tools >
Action > Load printer defaults.
2 — Reload printer firmware. See Updating Printer Firmware..
3 — If the printer does not recover from this error, call a service technician. This is not a user serviceable
item.