Tools
146
Sensor Profile
Use the sensor profile image (which will extend across several labels or tags) to troubleshoot the following
situations:
• The printer experiences difficulty in determining gaps (web) between labels.
• The printer incorrectly identifies preprinted areas on a label as gaps (web).
With the printer in the Ready state, print a sensor profile in one of these ways:
Compare your results to the examples shown earlier in this section. If the sensitivity of the sensors must be
adjusted, calibrate the printer (see Manual Media Calibration).
Using the buttons on
the user interface
1. Turn OFF the printer.
2. Press and hold FEED + CANCEL while turning ON the printer.
3. Hold FEED + CANCEL until the STATUS indicator ( ) is the
only indicator lit.
Using ZPL Send the
~JG command to the printer. See the Zebra Programming
Guide for more information about this command.
To Next Page
Loading...