Zebra ZQ511 User Manual

Troubleshooting
52
Troubleshooting Topics
No power
• Check that the battery is installed properly.
• Recharge or replace the battery as necessary.
• If using the battery eliminator to power the printer, ensure that it is connected properly to an active (ON)
source.
4 Bars 802.11 Signal Strength >75%
3 Bars 802.11 Signal Strength </=75%
2 Bars 802.11 Signal Strength </= 50% but >25%
1 Bar 802.11 Signal Strength </= 25%
0 Bars No network detected
On Bluetooth link established
Grayed Out Inactive
Blinking Data processing in progress
Steady No data being received
Blinking Out of media
Steady Media present
Blinking Media cover open
4 Bars >80% charged
3 Bars 60%-80% charged
2 Bars 40%-60% charged
1 Bar 20%-40% charged
0 Bars Low Battery
On Battery Eliminator present
(Replaces Battery icons)
On
(Media Out icon Off)
Printer in Segmentation Mode
On
(Media Out icon Off)
Printer in Draft Mode
Icon Status Indication
DC

Zebra ZQ511 Specifications

General

Print Method	Direct Thermal
Resolution	203 dpi
Operating Humidity	10% to 90% non-condensing
Storage Humidity	10% to 90% non-condensing
Maximum Print Width	2.83 inches/72 mm
Maximum Print Speed	5 in./127 mm per second
Media Sensors	Gap, black mark
Connectivity	Bluetooth, USB
Battery	3250 mAh, PowerPrecision+ Li-Ion
Durability	IP54-rated
Operating Temperature	14°F to 122°F (-10°C to 50°C)
Storage Temperature	-40°F to 158°F/-40°C to 70°C
Memory	256 MB Flash; 128 MB RAM
Supported Barcode Types	1D, 2D
Supported Media Types	Labels
Dimensions	2.75 in. H
Power Supply	AC adapter