Zebra ZT411 - Clean and Lubricate the Cutter Module

Routine Maintenance
101
Clean and Lubricate the Cutter Module
If the cutter is not cutting the labels cleanly or if it jams with labels, clean the cutter blades. After cleaning
the blades, apply lubrication to them to help extend the life of your cutter module.
CAUTION—ELECTRIC SHOCK: Turn off (O) the printer and disconnect it from the power source before
performing the following procedure.
1. Turn off (O) the printer and disconnect the AC power cord.
2. Raise the media door.
3. Remove media that is loaded through the cutter module.
CAUTION: The cutter blade is sharp. Do not touch or rub the blade with your fingers.
4. Loosen and remove the thumbscrew and lock washer on the cutter shield.