Printer Setup
17
Load the Media
Use the instructions in this section for loading roll or fanfold media in the appropriate label collection
method for your needs.
IMPORTANT: You are not required to turn off the printer power when working near an open printhead, but
Zebra recommends it as a precaution. If you turn off the power, you will lose all temporary settings, such as
label formats, and you must reload them before you resume printing.
Insert the Media into the Printer
1. Raise the media door.
2. Remove and discard any tags or labels that are torn or dirty or that are held by adhesives or tape.
To Next Page
Loading...