Printer Configuration and Adjustment
75
Print Menu
Connection > Bluetooth > Bluetooth Auth. PIN
Set the PIN used when Bluetooth authentication is enabled.
SGD command used:
bluetooth.bluetooth_pin (to set the PIN)
bluetooth.authentication (to enable authentication)
Connection > Bluetooth > Bluetooth Bonding
Controls whether the Bluetooth stack will “bond” or save link keys for devices that successfully
connect to the printer.
Accepted values: ON—Enables Bluetooth bonding.
OFF—Disables Bluetooth bonding.
SGD command used:
bluetooth.bonding
Print > Print Quality > Darkness
Set the print darkness to the lowest setting that provides good print quality. If you set the
darkness too high, the label image may print unclearly, barcodes may not scan correctly, the
ribbon may burn through, or the printhead may wear prematurely.
Accepted values: 0.0 to 30.0
Related ZPL command(s):
^MD, ~SD
SGD command used:
print.tone
Printer web page: View and Modify Printer Settings > General Setup > Darkness
To Next Page
Loading...