Printer Configuration and Adjustment
65
Connection Menu
System > Energy Saving > Energy Star
When Energy Star mode is enabled, the printer goes into a “sleep” mode after a timeout period,
thereby lowering power consumption. Press any button on the control panel to bring the printer
back to an active state.
Accepted values: ON, OFF
SGD command used:
power.energy_star.enable
power.energy_star_timeout
(to set the amount of idle time before Energy Star is invoked)
Connection > Networks > Reset Network
This option resets the wired or wireless print server and saves any changes that you made to
any network settings.
IMPORTANT: You must reset the print server to allow changes to the network settings
to take effect.
Related ZPL command(s):
~WR
SGD command used:
device.reset
Printer web page: Print Server Settings > Reset Print Server
Connection > Networks > Primary Network
View or modify whether the wired or wireless print server is considered primary. You may select
which one is primary.
Accepted values: Wired, WLAN
Related ZPL command(s):
^NC
SGD command used:
ip.primary_network
To Next Page
Loading...