Using a USB Host Port and the Print Touch Feature
177
Exercise 5: Enter Data for a Stored File with a Smart Device and Print a Label
The steps in this exercise may vary somewhat based on your smart device, on your service provider, or on
whether you already have the free Zebra Utilities app installed on your smart device.
Refer to the Zebra Bluetooth User Guide for specific instructions for configuring your printer to use a
Bluetooth interface. A copy of this manual is available at http://www.zebra.com/manuals.
1. If you do not have the Zebra Utilities app installed on your device, go to the app store for your device,
search for the Zebra Utilities app, and install it.
2. Pair your smart device with the printer by holding the smart device next to the NFC icon on the
printer.
a. If necessary, access the Bluetooth information about your printer using your smart device.
For instructions, refer to the manufacturer’s documentation for your device.
b. If necessary, select the Zebra printer’s serial number to pair it with the device.
c. After your smart device has been detected by the printer, the printer may prompt you to
accept or reject the pairing. If necessary, tap ACCEPT. Some smart devices will pair with
the printer without this prompt.
The printer and your device are paired.
3. Start the Zebra Utilities app on your device.
The Zebra Utilities main menu displays.
4. Perform these steps if you have an Apple device:
a. Tap the Settings icon in the lower-right corner.
b. Change the setting for Get Labels From Printer to ON.
c. Tap Done.
5. Tap Files.
The smart device gets data from the printer and displays it.
NOTE: This retrieval process may take a minute or more to complete.
To Next Page
Loading...