Printer Setup
48
Load the Ribbon
IMPORTANT: You are not required to turn off the printer power when working near an open printhead, but
Zebra recommends it as a precaution. If you turn off the power, you will lose all temporary settings, such as
label formats, and you must reload them before you resume printing.
Use ribbon that is wider than the media to protect the printhead from wear. Ribbon must be coated on the
outside for use in a standard printer. For more information, see What kind of ribbon can I use? on page 47.
1. Raise the media door.
CAUTION—HOT SURFACE: The printhead may be hot and could cause severe burns. Allow the
printhead to cool.
2. Open the printhead assembly by rotating the printhead-open lever upward.
To Next Page
Loading...