Specifications
192
Ribbon Specifications
Standard printers use ribbon that is coated on the outside. An optional ribbon spindle is available to use
ribbon that is coated on the inside. Contact your authorized Zebra reseller for ordering information.
ZT411 ZT421
Ribbon width MINIMUM* 2 in.** (51 mm**) 2 in.** (51 mm**)
Ribbon width MAXIMUM 4.33 in. (110 mm) 6.85 in. (174 mm)
Ribbon length MAXIUMUM 1476 ft (450 m)
Ribbon core inside diameter 1 in. (25 mm)
Ribbon roll outside diameter MAXIMUM 3.2 in. (81.3 mm)
* Zebra recommends using ribbon that is at least as wide as the media to protect the printhead from wear.
** Depending on your application, you may be able to use ribbon narrower than 2 in. (51 mm), as long as the ribbon is wider than the media being
used. To use a narrower ribbon, test the ribbon’s performance with your media to assure that you get the desired results.
To Next Page
Loading...