Routine Maintenance
108
Replacing Printer Components
Some printer components, such as the printhead and platen roller, may wear out over time and can be
replaced easily. Regular cleaning may extend the life of some of these components. See Cleaning
Schedule and Procedures on page 95 for the recommended cleaning intervals.
Ordering Replacement Parts
Zebra ™ printers are designed to work only with genuine Zebra printheads, thus maximizing safety and
print quality. Contact your authorized Zebra reseller for part ordering information.
Recycling Printer Components
The majority of this printer’s components are recyclable. The printer’s main logic board may
include a battery that you should dispose of properly.
Do not dispose of any printer components in unsorted municipal waste. Please dispose of the
battery according to your local regulations, and recycle the other printer components according
to your local standards. For more information, see http://www.zebra.com/environment.
Storing the Printer
If you are not placing the printer into immediate operation, repackage it using the original packing
materials. You may store the printer under the following conditions:
• Temperature: –40°F to 140°F (–40° to 60°C)
• Relative humidity: 5% to 85% non-condensing
Lubrication
The only lubrication needed for this printer is for the cutter module. Follow the instructions in Clean and
Lubricate the Cutter Module on page 101. Do not lubricate any other parts of the printer.
CAUTION—PRODUCT DAMAGE: Some commercially available lubricants will damage the finish and the
mechanical parts if used on this printer.
To Next Page
Loading...