Printer Configuration and Adjustment
83
RFID Menu
RFID > RFID Status
Display the status of the RFID subsystem of the printer.
Related ZPL command(s):
^HL or ~HL
SGD command used: rfid.error.response
RFID > RFID Test
During the RFID test, the printer attempts to read and write to a transponder. No printer
movement occurs with this test.
To test an RFID label:
1. Position the RFID label with its transponder over the RFID antenna array.
2. Touch Start.
The results of the test are shown on the display.
SGD command used:
rfid.tag.test.content and rfid.tag.test.execute
To Next Page
Loading...