Zebra ZT411 - Page 82

Printer Configuration and Adjustment
82
Print > Applicator > Start Print Mode
Determines if the applicator port’s “Start Print” signal is in level mode or pulse mode.
Accepted values: Pulse—Start Print signal must be deasserted before it can be
asserted for the next label.
Level—Start Print signal does not need to be deasserted to print
the next label. As long as the Start Print signal is low and a label is
formatted, a label prints.
Related ZPL command(s):
^JJ
SGD command used:
device.applicator.start_print
Print > Applicator > Error on Pause
Determines how applicator port errors are treated by the printer. Enabling this feature also
causes the “Service Required” pin to be asserted.
Accepted values: ENABLED, DISABLED
SGD command used:
device.applicator.error_on_pause
Printer web page: View and Modify Printer Settings > Advanced Setup > Error on
Pause
Print > Applicator > Applicator Reprint
Specifies if a high or low value is required for an applicator to reprint a label.
Enables or disables the
~PR command, which when enabled reprints the last printed label. It
also enables the Reprint button on the Home screen.
Related ZPL command(s):
^JJ and ~PR
SGD command used: device.applicator.reprint