Printer Setup
18
3. Pull out the media supply guide as far as it goes.
4. Insert roll or fanfold media into the printer. The media loading path is the same for both roll and fanfold
media, so this is the only step that will be different.
Roll Media—Place the roll of media on the media supply hanger. Push the roll as far back as
it will go.
Fanfold Media—Fanfold media can be stored behind or under the printer. Depending on where
the media is stored, feed the media from behind or through the bottom access slot and drape it
over the media supply hanger.
Rear Feed Bottom Feed
To Next Page
Loading...