Printer Setup
29
8.
Complete this step only if you want to use Peel-Off mode with Liner Take-Up. Your printer must have
the Liner Take-Up option or the Rewind option installed. Follow the instructions for your printer option. If
you are not using Liner Take-Up, continue with step 9 on page 33.
a. Thread the liner into the slot below the peel assembly.
Rewind Option Liner Take-Up Option
b. Feed the liner under the media
alignment roller (1).
Slide the liner into the slot in the
liner take-up spindle (1).
To Next Page
Loading...