Routine MaintenanceRoutine Maintenance
96
Cutter
module
If cutting continuous,
pressure-sensitive media
Solvent* After every roll of media (or more often,
depending upon your application and media).
If cutting tag stock or
label liner material
Solvent* and
air blow
After every two or three rolls of media.
Tear-off/peel-off bar Solvent* Once a month.
Take-label sensor Air blow Once every six months.
Table 4 Recommended Cleaning Schedule
Area Method Interval
*Zebra recommends using the Preventive Maintenance Kit (p/n 47362 or p/n 105950-035 - multipack). In place of this kit, you may
use a clean swab dipped in 99.7% isopropyl alcohol.
For 600 dpi printers, use Save-a-Printhead cleaning film. This specially coated material removes contamination buildup without
damaging the printhead. Call your authorized reseller or distributor for more information.
To Next Page
Loading...