Axiovert 40
B 46-0031 e 11/03 IX
NOTES ON INSTRUMENT SAFETY
The Axiovert 40 microscopes have been designed, produced and tested in compliance with DIN 61010-1
(IEC 1010-1) and DIN EN 61010-2-101 safety requirements for electrical measuring, control and laboratory
instruments, and meet the requirements of Appendix I of directive 98/79/EC.
Conformity to the given standards is documented by the
marking.
This operating manual includes information and warnings that must be observed by the user.
NOTE
This symbol is a warning, which you must observe under all circumstances.
CAUTION
This symbol is a warning, which indicates a hazard to the instrument or instrument system.
CAUTION
This symbol is a warning, which indicates a hazard to the user of the instrument.
CAUTION
Hot surface!
CAUTION
Emission of UV radiation!
CAUTION
Disconnect the instrument from the line before opening it!
To Next Page
Loading...
