Zeiss Axiovert 40 - Specimen Stage Glass; Heatable Stage and Temperable Microscope Stage; Mounting the Specimen Stage Glass

Axiovert 40
11/03 B 46-0031 e
2Ć24
2.8.1 Specimen stage glass
The specimen stage glass (2Ć29ā/ā3) enables conveĆ
nient working with simultaneous observation of the
objectives.
Installation
• Put the specimen stage glass onto the stage
mounting point using the spacers.
• Using fastening screws (2Ć29ā/ā2), fasten the speciĆ
men stage glass to the stand.
• Cover the rear hole on the surface of specimen
stage glass with cap (2Ć29ā/ā1).
2.8.2 Heatable stage and temperable microscope stage
A heatable stage and a temperable microscope stage are available for the Axiovert 40 microscope.
• Heatable stage (471820-9901-000) including three spacers
• Temperable microscope stage (411881-0000-000) including three spacers
The use of the heatable stage requires:
• Control unit Tempcontrol 37 (1-Kanal) (000000-1116-057)
If additionally you need a pre-heating plate, it is recommended to order the Tempcontrol 37-2 control unit
(000000-1052-320).
The use of the temperable microscope stage requires:
• Cooling thermostat RE 106 (230 V) (000000-1116-068). This device is also available for 105 V lines.
Fig. 2Ć29 Mounting the specimen stage glass
1
2
3