Axiovert 40
11/03 B 46-0031 e
3Ć8
(4) Replacing reflector modules FL P&C on 3-position reflector slider P&C
The reflector modules FL P&C are equipped in the factory with the appropriate filter sets consisting of excitaĆ
tion filter, dichroic beam splitter and barrier filter.
However, the reflector modules may be equipped with any FL filter set.
Two examples of available filter sets:
Filter set 09 shift-free (blue excitation) (4888009-0000-000) consisting of EX BP 450Ć490
BS FT 510
EM LP 515
Filter set 15 shift-free (green excitation) (488015-0000-000) consisting of EX BP 546ā/ā12
BS FT 580
EM LP 590
For further filter sets, refer to the Price List.
• Remove 3-position reflector slider P&C from AxĆ
iovert 40 CFL microscope.
• Loosen fastening screws (3Ć7ā/ā3) on the right and
left and remove cover (3Ć7ā/ā1) upward.
• To remove a reflector module FL P&C no longer
used, withdraw it first from the upper clips (3Ć7ā/ā2)
and then from the lower ones (3Ć7ā/ā5), and then
lift it out obliquely.
• Holding it on the holding elements arranged on
the right and left (see arrows), insert the reflector
module FL P&C (3Ć7ā/ā6) obliquely from top in the
bottom clips on the bottom part (3Ć7ā/ā4) of the reĆ
flector mount (in the required place I, II or III).
Then, push against the top part of the module unĆ
til it reliably snaps in the upper clips, too.
• When all reflector modules FL P&C have been inĆ
serted, reattach cover (3Ć7ā/ā1) and tighten both
fastening screws.
Fig. 3Ć7 Replacing the reflector modules FL P&C
To Next Page
Loading...
