Programming - Front Panel
025-9567E 93
Entry Mode Description
0
DIRECT - The Select Relays will close prior to the tones being
sent and remain closed for the entire time of the transmission.
This mode should be used if the Select Relays used to directly
key transmitters. This is the default mode.
1
MOMENTARY - The Select Relays will close, then open prior
to the PTT relay closing and tones being sent. This mode
should be used if the model 25 is mounted in a console and
the Select Relays are connected in parallel with the channel
select buttons of the console.
Question 2
At the Question 2 prompt, enter a 2-digit response (00 to 99) to set the Keyup Delay. The
range is from zero seconds to 9.9 seconds in 0.1 second increments. The default setting is
zero seconds (enter 00). A typical value for this parameter is 1 second (enter 10). This sets
the delay time between the Model 25 keying PTT and the generation of the first paging tone.
Question 3 - Review Before Send
At the Question 3 prompt, enter a single-digit response (0 or 1) enable or disable the Review
Before Send function. The default setting is “0” for Disabled.
When Review Before Send is enabled, the instant call button at the lower left corner of the
Instant Call array must be pressed in order to send the calls assigned to the previously
selected instant call button. When Review Before Send is disabled, the instant call button at
the lower left operates as a normal instant call button, just like all the rest.
Question 4 - Stack Delay
At the Question 4 prompt, enter a 2-digit response (00 to 99) to set the Stack Delay. The
Stack Delay is the time between pages whenever an instant call stack is being sent. The range
is zero seconds to 9.9 seconds in 0.1 second increments.
The default setting is 1 second, which is entered “10”.
To Next Page
Loading...
