Programming - Front Panel
76 025-9567E
The duration of the gap will require a 3-digit entry (000 to 999). The increment used is 0.01
seconds, so a decimal point in the entry is not required.
Question 5 - Second Tone Duration
The duration of the second tone will require a 3-digit entry (000 to 999). The increment used
is 0.01 seconds, so a decimal point in the entry is not required. Any value between 0.00 and
9.99 seconds may be used. 1.00 second (enter 100) is standard for Quick Call I.
Saving the Changes
Once the single-digit response for “Question 5” has been entered, the Model 25 will
immediately begin to load all changes made in this section to memory to be used until new
changes are made. During the time that the Model 25 is loading this information to memory,
the display will appear as shown here.
CAUTION
Do not remove power or press the RESET button while the Model 25 is loading the
memory, otherwise incorrect information could be loaded requiring reprogramming.
Once the Model 25 completes the loading procedure, it will return to the first question in the
two-tone programming section, “Question “bo”” on page 69. You may select another leading
digit to format or press RESET to exit the programming mode back to the idle state.
5/6-Tone Sequential (Motorola)
Question 1 - Channel Select Relays
This question works the same way for most paging formats. Please see “Question 1 - Channel
Select Relays” on page 72 for a description.
Question 2 - Tone Group Selection
To Next Page
Loading...
