Programming - Front Panel
025-9567E 89
Question 7
At the following prompt, select an alert tone to follow the custom call. This is a single digit
entry (0 to 3). Table 26 lists the alert tones available. The alert tone selected will be
transmitted each time the custom call is made, whether called manually or from an instant
call button.
Table 26. Alert Tone Numbers
Entry Alert Tone
0 No Alert
1 Slow Siren
2 Fast Siren
3 Hi/Low Warble
Once the single-digit response for “Question 7” has been entered, the Model 25 will
immediately begin to load all changes made in this section to memory to be used until new
changes are made. During the time that the Model 25 is loading this information to memory,
the display will appear as shown here.
CAUTION
Do not remove power or press the RESET button while the Model 25 is loading the
memory, otherwise incorrect information could be loaded requiring reprogramming.
Once the Model 25 completes the loading procedure it will return to the first question in the
Custom Call programming section, “Question “bo”” on page 69. You may program another
custom call or press RESET to exit the programming mode back to the idle state.
PROGRAMMING SECTION 4 - INSTANT CALL BUTTON SETUP
The Model 25 allows a single call or multiple calls of various formats to be assigned to
Instant Call buttons. When an Instant Call button is pressed the encoder will sequentially
send each of the calls assigned to that button. In this section, the individual calls will be
assigned to the Instant Call buttons.
To Next Page
Loading...
