Programming - Front Panel
025-9567E 83
Question 5 - Number of Beeps/Delay Time
The encoder expects a single-digit response to this question (1 to 9). This entry does double
duty in the Model 25 for alert tones.
If the alert type assigned to the instant call button (on entered manually at the keypad) is a
beep alert, the number entered here determines how many beeps are generated in the alert
tone.
If the alert type assigned to the instant call button (on entered manually at the keypad) is a
delay, the number entered here sets the duration of the delay in seconds.
Saving the Changes
Once the single-digit response for “Question 5” has been entered, the Model 25 will
immediately begin to load all changes made in this section to memory to be used until new
changes are made. During the time that the Model 25 is loading this information to memory,
the display will appear as shown here.
CAUTION
Do not remove power or press the RESET button while the Model 25 is loading the
memory, otherwise incorrect information could be loaded requiring reprogramming.
Once the Model 25 completes the loading procedure, it will return to the first question in the
two-tone programming section, “Question “bo”” on page 69. You may select another leading
digit to format or press
RESET to exit the programming mode back to the idle state.
Digitone
Question 1 - Channel Select Relays
This question works the same way for most paging formats. Please see “Question 1 - Channel
Select Relays” on page 72 for a description.
To Next Page
Loading...
