Table of content
1. Safety Instructions 5
2. Returning a device 6
2.1. Packaging 6
3. Repairing Printed Circuit Boards 6
4. Special incidents 6
5. Device general description 7
5.1. Over view 7
6. Electronic 9
6.1. Overview 9
6.1.1. Electronic description of the PhySys Edition SD device 9
6.1.2. Electronic description of the VacoP device 14
6.2. Pin Assignments 16
6.2.1. Overview PhySys Edition SD device 16
6.2.2. Overview Vaco device 17
6.2.2.1. VacoP User connection 17
6.2.2.2. Power supply connection (ST1001) 17
6.2.2.3. Jumper (JP1001-JP1004) 17
6.2.2.4. VacoP User connection (ST1201) 17
6.2.2.5. Stimulating current connection (ST1204) (PhySys Edition SD/ Vacoboard) 17
6.2.2.6. Stimulating current connection (ST1203) (VacoP mainboard/ suction electrodes) 18
6.2.2.7. Pump connection (BU1401) 18
6.2.2.8. Valve connection (ST1502) 18
6.2.2.9. Water level sensor connection (ST1202) 18
7. Software 19
7.1. Installation programme update 19
7.1.1. Necessary tools 19
7.1.2. Download and Installation of the SD-card-update program 19
7.2. Processing the SD-card update 23
7.3. Update the PhySys Edition SD 25
8. Mechanic 28
8.1. General Overview 28
8.1.1. Device Structure of the PhySys Edition SD 28
8.1.2. Device Structure of the Vaco device 30
8.2. Accessory List 31
8.3. Replacement of device components 31
8.3.1. Replacement of PhySys Edition SD components 31
8.3.1.1. Opening the rear part of housing 31
8.3.1.2. Mounting the rear part of housing 32
8.3.1.3. Removing of the front part of housing 32
8.3.1.4. Mounting the front part 33
8.3.1.5. Replacement of the speaker 33
8.3.1.6. Replacement of the main board 33
8.3.1.7. Replacement of the Display 34
8.3.1.8. Replacement of the battery 35
8.3.1.9. Replacement of power inlet element 36
8.3.1.10. Replacement of power supply board 37
8.3.2. Replacement of the VacoP components 38
8.3.2.1. Replacement of the water separator 38
8.3.2.2. Replacement of the pump 39
8.3.2.3. Replacement of the vaco board 40
To Next Page
Loading...
