GET STARTED / CALIBRATION
23
Changing the height of the working table (not recommended unless you know
what you’re doing) made by turning screws in the glass plate with a Philips nr. 2
screwdriver. A half rotation of the screw results in about 0.35mm dierence.
If you have a dierence between le, and right half of the table you should rst check
the table corner heights by using a ruler (right side picture).
Generally, these changes are not required by the rst use, as the machine comes
calibrated - slight dierences might occur due to transport or unpacking.
If you are experiencing any problems with balancing the table or X axis of the machine,
consider purchasing the clip-on add-on for the ZMorph called Touch Probe.
It will make calibration much easier and is available in our shop.
Video tutorial demonstrating this can be found here: https://vimeo.com/118746466
B
To Next Page
Loading...
Need help?
General
