Zmorph 2.0 S User Manual

GET STARTED / CALIBRATION
24
EXTRUDER TEST
Before you start printing, the extruder needs to be tested.
To do that, move the nozzle up
by 20mm. In the panel you should go to:
OK >> Move Axis >> Z axis
(press two times for 20mm).
1
And heat it to 235-245°C
- if using ABS, or 185-195 - if using PLA.
2
Aer temperature stabilises,
press extrude (E button in Voxelizer)
few times.
In panel you should go to:
Filament Menu >> Extrude/Retract
>> Extrude
3

Zmorph 2.0 S Specifications

General

Brand	Zmorph
Model	2.0 S
Category	3D Printers
Language	English