GET STARTED / CALIBRATION
20
To calibrate the print surface,
you should position the nozzle in the
middle of print bed, and home
the Z axis. Before homing, make sure
the nozzle tip and glass bed itself
is clean.
Use Calibrate >> Home To Center
in the panel menu.
1
When homing the Z axis, watch
the nozzle carefully - it should come
down to glass surface level, rise up
a little, and go down slowly again.
2
WORKING TABLE (BED CALIBRATION)
In order to work with 3d printing, it is essential to properly calibrate the print surface.
The machine always comes as calibrated.
No calibration is usually necessary to start printing.
If your machine got miscalibrated in transport, follow the instructions below.
!
To Next Page
Loading...
