MAINTENANCE AND FUNCTION / SPECIFICATIONS
77
working area
250x235x165mm,
expandable to 300x235x165mm
with special table
recommended layer height
0.3mm-0.05mm (ABS)
0.3-0.01mm (PLA)
recommended print speed
40mm/s - normal speed
75mm/s - high speed
200mm/s - extreme speed. Works
only for simple geometries, no re-
traction, large builds.
Higher speeds might be used
with lower layer heights
For perimeters, we recommend
10-20% slower speed
for better quality
recommended temperature
for plastic extruder
235-245°C (ABS)
185-200°C (PLA)
recommended bed
temperature
100-110°C (ABS)
60-70°C (PLA)
135°C (NYLON)
number of axis 5
electronics Sunbeam 2.0 (rev. C)
SPECIFICATIONS
To Next Page
Loading...
