Zmorph 2.0 S - LAN Connectivity Setup

GET STARTED / PRINTER CONNECTION
13
If your network doesn’t use DHCP
(unlikely), or you want it to have static IP
address, edit cong le on SD card, and
change network settings (at the end).
3
You can also connect to the machine using Telnet protocol or HTTP.
To use it, follow these steps:
Connect the machine
to a router in your network using
the cable provided. If your network
has DHCP active (most networks do),
ZMorph will get it’s IP address
and display it on front panel.
1
Type this address to
Voxelizer. Click ‘Connect’.
Voila!
2
LAN CONNECTIVITY