Zmorph 2.0 S - Troubleshooting; Common Printer Issues and Solutions

MAINTENANCE AND FUNCTION / TROUBLESHOOTING AND ADJUSTMENTS
66
TROUBLESHOOTING
Symptom: no connection with the machine.
Reason: dropped USB connection
Solution: insert/remove USB cable. Voxelizer should reconnect automatically.
If it doesn’t , run the program again and repeat the steps.
If this doesn’t help, reset the machine.
 Symptom:plasticdoesn’tow,
even though extruder pulley is rotating normally.
Reason: blocked nozzle, temperature too low, nozzle blocked by glass table
(pushed against it), or extrusion speed too high.
Solution: removing the lament, cutting 10-20cm o, feeding it back in.
Fixing one of the reasons stated above (cleaning the nozzle,
increasing the temperature, lowering extrusion speed
or increasing the gap between glass and nozzle).
Symptom: plastic blocks in extruder from time to time.
Reason: uneven diameter of the lament (above 3.1mm).
To verify, measure lament in several places.
Solution: changing the material to one from dierent source.
 Symptom:printisbrittle,layersdon’tsticktogether.
 Plasticdoesn’towevenly.
Reason: partially blocked nozzle or temperature too low.
Solution: cleaning the nozzle or increasing the temperature.